Relax Leak Sealer - 1 Litre
Directions for use
Bypass the filter when using this product, the leak sealer is not recommended to repair torn vinyl swimming pool liners. For this see our vinyl repair kits.
Relax Leak Sealer is designed to seal minor leaks (where the water level drops less than 2.5cm per day in a 60,000 litre pool). Large defects will require proper plumbing and maintenance repairs.
1. Turn the pool pump off and remove any automatic pool cleaner from the pool
2. Set the filter on by-pass or re-circulate. If neither of these settings are available remove the filter grids or cartridges from the filter prior to commencing treatment. Note: Fine fountain jets will be block when using this product, if these jets can't be removed then don't use this product.
3. Leak Sealer should be added to the pool at the rate of 1 litre per 60,000 litres of pool water. There are two ways of adding depending on location of the leak
a) A leak in pool walls or floors - Add the leak sealer directly into the pool water to the area identified as having the leak, if you haven't identified the area distribute it evenly around the pool.
b) Leak in pipework - Add the correct dose directly into the skimmer
4. Wait 30 minutes and then turn the pump on. Leave the pump on for a minimum of 8 hours
5. Mark the water level and check after 24 hours
6. A second application then may be required
7. Return the filter setting to normal once the leak sealer has taken effect. Swimming may be resumed 24 hours after addition if product.
General Precautions
Never mix with any other chemicals including cleaning products, weedkillers and chlorine products, as a dangerous reaction may occur. Keep out of reach of children. Always use clean plastic container when dilutiing. Always wash hands thoroughly before and after using this product. Store in a cool dry place. Always shake bottle before use.
Danger
Causes skin irritation, causes serious eye damage and may cause respiratory irritation avoid breathing fumes, wear protective gloves and eye protection. If on skin, gently was with plenty of soap. If in eyes rinse cautiously with water for several minutes and remove any contact lenses. If eye irritation persists get medical advice. If inhaled, move to fresh air.
1 litre sodium silicate mixture - SDS060 in the event of an emergency phone the Relax 24 hour helpline 0800 043 0892.
Validate your login